Product Features
- Sold in Pairs (Right and Left Set)
- Manufactured from 3/16” USA Steel
- Slots in product create added Tie-Down Points
- Antenna/Flag Mount hole in top
- Includes Black texture Powder-coat
Product Details
Direct Bolt in Toyota Tacoma Bed stiffeners keeps your Tacoma's Bed from cracking under the added stress of rooftop tents and rack systems. Install in Minutes, and Uses Factory hardware. Fits 2016 - Current Tacoma's
Prop 65
WARNING: Operating, servicing and maintaining a passenger vehicle or off-highway motor vehicle can expose you to chemicals including engine exhaust, carbon monoxide, phthalates, and lead, which are known to the State of California to cause cancer and birth defects or other reproductive harm. To minimize exposure, avoid breathing exhaust, do not idle the engine except as necessary, service your vehicle in a well-ventilated area and wear gloves or wash your hands frequently when servicing your vehicle. For more information go to www.P65Warnings.ca.gov
FREE SHIPPING ON ALL BUMPERS
Best on the market
The design, fit, and finish is unlike anyone else’s on the market. The boxed design made from 3/16 is much more substantial for strengthening the bed sides. I was so impressed I decided to go ahead and get my front bumper from them as well.
United StatesNicely designed and made.
Straight forward install, however this is not a no-drill product, especially if you intend to actually use the bed supports. A single 12mm bolt does not make for much side wall support. There are three pre drilled holes to add additional side wall support, but there is no documentation of any kind to make a parts store run a quick and easy ordeal. Overall this design is by far the best, being enclosed instead of a L bracket design makes it more friendly in case you knee it, or need to slide equipment over it.
